Flip up Helmet

[Steve_D]

The pinlock has never fit properly which is a pain in the ass!

Yeah, same on my Lazer helmet. Very annoying - it shouldn't be that hard! This is obviously the real reason my Arais cost a fortune - they design the visor so the Pinlock fits perfectly!

I had the same problem with the pinlock insert on one of my helmets - it kept misting up in between the visors due to the poor fit. I phoned up the manufacturer to complain and they told me that the pinlocks were concentric and adjustable. Half a turn on each of them with a small screwdriver tightened the insert and cured the problem. I never knew that! Yours isn't the same by any chance, is it?

[MrGrumpy]

The pinlock has never fit properly which is a pain in the ass!

Yeah, same on my Lazer helmet. Very annoying - it shouldn't be that hard! This is obviously the real reason my Arais cost a fortune - they design the visor so the Pinlock fits perfectly!

I had the same problem with the pinlock insert on one of my helmets - it kept misting up in between the visors due to the poor fit. I phoned up the manufacturer to complain and they told me that the pinlocks were concentric and adjustable. Half a turn on each of them with a small screwdriver tightened the insert and cured the problem. I never knew that! Yours isn't the same by any chance, is it?

Thats the system on the new Max Vison inserts, but the old ones had pins in, which weren't so easy to adjust - but the pins did hold the insert in under tension, which normally holds the insert correctly. But when I say the pinlock on the Lazer didn't fit, I'm talking about a huge gap of several mm at the bottom! I eventually put some masking tape on to seal it.

[Ferrit]

Should not have a gap that big....you did have it the right way up I ask because on my shoei it always looked odd because it looked right the other way up.